Wouxun KG-UVD1P Bedienungsanleitung PDF herunterladen (Seite 15)

9 Other Functions

Thus far we have seen 19 of 30 menu items in action. Most of the other menu function items below are “set and forget” features:

Set squelch level: MENU 2 MENU ▼ to select 0 through 9 MENU EXIT

(5 is default and reasonable. Use higher numbers if suffering from intermod interference. If green receive LED flickers

consider increasing squelch level)

Enable transmit beeps: MENU 5 MENU ▼ to select OFF = no beeps, BOT = beep at transmission start, EOT = beep at transmission end,

BOTH = beeps at begin and end, MENU EXIT

Set VOX level: MENU 7 MENU ▼ to select either OFF or levels 1 through 10 MENU EXIT

(voice activated transmit switch, VOX, is not recommended for handheld radios)

Set FM bandwidth: MENU 8 MENU ▼ to select either WIDE (25KHz) or NARROW (12.5KHz) , MENU EXIT

(recommendation is narrow for most modern repeater systems. If selected an N is displayed on upper right of the LCD

display)

Set transmit time-out alarm: MENU 1 0 MENU ▼ to select 1 through 10 for # of seconds for TOT alarm, MENU EXIT

(alerts user when TOT is about to activate. See Section 6 concerning time-out timer)

Set power on message: MENU 1 2 MENU ▼ to select either OFF , BATT for battery voltage display, or MSG for a welcome message,

MENU EXIT

(welcome message can be programmed only with software)

Set busy channel lockout: MENU 1 3 MENU ▼ to select either OFF or ON , MENU EXIT

(disables transmit if the PTT button is pressed when a frequency is busy)

Enable receive CTCSS (tone squelch): MENU 1 5 MENU ▼ to select 67.0Hz through 254.1Hz as a tone squelch (CTCSS RX) ,

MENU EXIT

(the tone squelch opens only when receiving a signal with the same pre-programmed subaudible tone.

Useful when distant repeaters have same transmit frequencies.)

Enable receive DCS: MENU 1 7 MENU ▼ to select D023N through D754N digital coded squelch code for receive , MENU EXIT

1 2 ... 10 11 12 13 14 15 16 17

Keine Kommentare

Wouxun KG-UVD1P Bedienungsanleitung Seite 15